-
One-Step Pressing, it is rolling only once to achieve the designed thickness and density of the battery electrode. Two-Step Pressing, it is rolling the battery electrode to a certain thickness (such as 90μm) at first time, and achieve the designed thickness (such as 70μm) and desired density through the second time pressing. The main purpose of the rolling press is to control the electrode in the ...
read more
-
If the surface of the prepared battery electrode is flat, there is no significant particulate matter. In addition, there is no obvious material drop in the baking, room temperature cooling and transfer process, so it can be preliminarily judged that the preparation of pole sheet is qualified. Further comparison can be made on the quality, thickness of the battery electrode, and the dropping of the...
read more
-
Lithium Chip Metal lithium chip used in the laboratory can provide a far greater source of lithium, Lithium chip shall have less impurities and the size shall be larger than that of the electrode to be measured, and the purity of lithium chip shall not be less than 99.9%. General requirements for lithium chip in the preparation of coin cell: diameter 15 ~ 15.8mm (the corresponding electrode size i...
read more
-
Before starting, place the prepared button battery assembly parts and materials in the glove box. We can offer a full set of coin cell parts and materials, including coin cell case, coated electrode, cathode and anode materials, electrolyte, coin cell spacer, wave spring, belleville washers, battery separator. 1. Place the spacer and the cathode electrode into the coin cell cathode case one by one...
read more
-
After electrode coating, electrode through drying process in oven and the coated electrode becomes loose. If used directly, the cathode material and anode material is easy to fall off and damage after being soaked by electrolyte. The electrode can be pressed by the battery electrode roller machine. The stability, firmness and electrochemical properties of the pressed electrode were improved, and t...
read more
-
The lithium battery electrode is a coating composed of particles. During the preparation of the electrode, a uniform wet slurry is applied to the metal current collector foil, and then the solvent in the dehumidification coating is removed by drying. Battery binder or dispersant as well as conductive agent such as carbon black are often added to the battery electrode slurry. Although the solid con...
read more
-
When preparing the electrode of lithium ion battery, aluminum foil is used as the cathode current collector foil, while copper foil is used as the anode current collector foil. If a single smooth foil is used, it is recommended to apply the foil on the rough side to increase the bonding force between the current collector foil and the materials. There is no special requirement for the thickness of...
read more
-
As the core product of replacing the fuel - powered vehicle, new energy vehicle has been accepted by more and more users. Similarly, as one of the components of new energy vehicles, power battery has a more and more promising market. As a high-tech enterprise in the field of lithium-ion battery and supercapacitor, TOB has always been committed to the development of the fuel cells, TOB New Energy c...
read more
-
Electrode Preparation is a key part in the whole battery manufacturing process, the quality of electrode directly affects the next step. The battery slurry preparation is a non - Newtonian high viscosity fluid which is formed by mixing the active materials, binders, solvents and other powders evenly. This slurry requires a certain viscosity, good fluidity and a sufficiently small particle size. So...
read more
subscribe to us 
中文
français
Deutsch
italiano
español
português
Nederlands
日本語
한국의
